Important! User Maintenance Instructions for ACRYLIC and LASCOAT Bath Fixtures.
Use only recommended cleaners and procedures described herein. Use of other materials and methods may harm your bath fixture and will void the Warranty.
For normal cleaning: Never use abrasive cleaners such as scouring powders or pads, steel wool, scrapers, sandpaper or anything else that could scratch or dull the surface of your LASCO unit. Instead, use warm water and liquid detergents, especially those bathroom cleaners recommended for cleaning fiberglass, such as Top Job All-Purpose; Ajax All-purpose; Mr. Clean All-Purpose; Boraxo Bathroom; Fantastik Bathroom; Lysol Bathroom; Woolworth Bathroom; Kroger Bright Basin, Tub & Tile; Bath; chlorine bleach; Easy-Off Mildew Stain Remover; X-14 Mildew Stain Remover; Lime-A-Way Bathroom/Kitchen; Liquid Spic & Span or similar materials.
To restore a scratched or dull unit: use an automotive polishing compound applied with a clean cotton rag. Follow with a light coat of liquid wax ("J" wax or similar); buff to shine. Deep scratches, should they occur, require professional restoration.
To remove adhesive: Try 3-M Natural Cleaner, De-SolvIt or naphtha (lighter fluid). Saturate a small, white, cotton rag and rub vigorously until the adhesive dissolves and disappears. These solvents are highly flammable and must be used sparingly and with caution. Do not smoke or permit others to do so. Make sure all nearby heating devices (including pilot lights) are extinguished. Do not allow solvent to go down the drain. Make sure not to contact plastic drain grates or other synthetic materials.
CAUTION NOTES When using any cleaning or polishing materials, make sure to read and follow all package instructions carefully. Wear rubber gloves at all times and avoid contact with eyes, skin, clothing, rugs and furnishings. Make sure all residues are rinsed off thoroughly.
Rubber mats: If you use a rubber or plastic "anti-skid" mat, make sure to remove it from the unit after each shower to avoid harm to the surface finish.
Hard water: Water in certain regions, if not wiped up after bathing/showering, may cause fading of some bath fixture colors. This is a natural occurrence beyond our control. (See Warranty.)
Whirlpool Care & Maintenance Guide: Click here to download pdf.
|
